Mark Line Blasting Machine Mark Line Shot Blaster
Input voltage: Customized
Total power (kw): 18.3
Blast motor power (kw): 1×11kw
Walking motor power (kw): 1.1kw
320mm Mark Line Blasting Machine Shot Blaster
Product detail
Preparation before operation
Equipment inspection
Check that the power line connection is correct and that the voltage is stable and meets the equipment requirements. Inspect transmission parts such as belts to ensure they are intact, without severe wear or looseness. Examine the blades and other wear parts in the shot blaster, and replace them promptly if necessary. Verify that the elevator and separator operate smoothly and listen for any abnormal sounds or vibrations.
Material preparation
Select the appropriate type and specification of projectiles based on the material and requirements of the floor to be treated, ensuring that the projectiles meet quality standards and are available in sufficient quantity.
Safety protection
Operators must wear personal protective equipment such as protective clothing, safety goggles, and earplugs. Check that all safety devices on the equipment, including emergency stop buttons and protective covers, are intact and functioning properly. Ensure the work area is clean, spacious, free of flammable or explosive materials, and has good ventilation and lighting.
Operation steps
Start by plugging the power cord into the socket and turning on the power switch. Press the air compressor's start button, and wait until it is running normally before proceeding to the next step..
Parameter Setting: Set the shot blasting time according to the floor material. Adjust the shot blasting amount based on the floor's surface condition and treatment requirements. Set the appropriate shot blasting speed according to the floor's material and hardness to avoid damage.
Shot Blasting: Place the floor to be treated within the working area of the shot blasting machine, ensuring it is stable and properly positioned so the projectiles can fully cover the surface. Once confirmed, press the start button to begin the shot blasting process.
Monitoring Operation: During the operation of the shot blasting machine, the operator should closely monitor the equipment's performance and observe the shot blasting effect on the floor surface, checking for any uneven blasting. At the same time, the operator should pay attention to various equipment parameters, such as whether the current and voltage remain stable within normal ranges, as well as the consumption of projectiles.
Completed Treatment: When the floor achieves the expected shot blasting effect, press the stop button to stop the shot blasting machine.
Post-operation matters
Clean the equipment and remove any residual projectiles, dust, and debris inside. Turn off the power switch and related equipment, such as the air compressor, and disconnect the power supply and gas source. Perform daily inspections of the equipment to check for any damaged or abnormal parts, preparing it for the next use.
Product use
Hot Tags: mark line blasting machine mark line shot blaster, China mark line blasting machine mark line shot blaster manufacturers, suppliers, bead blaster floor machine, industrial shot blaster, used floor shot blaster for sale, 2 20DT Shot Blasting Machine, steel shot machine, Concrete Floor Shot Blasting Machine
You Might Also Like
Send Inquiry